[[email protected]]

So I have been doing some air system checks and trying to find leaks as well as modifying my 120v air compressor. Of course I came across leaking Norgren hand valves for the gen slide and also the one for sliding out the ice chest. 

I noticed in this thread that some of you said you tried to rebuild the valves, I am wondering how did you go about that? I also pulled one apart and tried to use o-rings in it but some of the seals are not o-rings, they are more of a rubber disc. So I did some searching to see if I get a rebuild kit for these valves and I came across a spec sheet that gives a rebuild kit number for each unit. I have attached that catalog for reference. 

I found the rebuild kit is Norgren Part #54237-56, this is the spool piece with the rubber rings already on it.

I will report back if this fix works or not when I get the spool pieces installed.

I ordered it directly from Norgren at $29.27 each. 

https://www.norgren.com/en-us/products/54237-56