[whited44]

So I was able to temporarily hook this up and test it today. However only 1 of the compressors is running. 

I’ve attached a diagram for some diagnostics help.

On compressor 1 on the control board the black wire goes to the right side of the capacitor 

And compressor 2 on the control board the yellow wire goes to the left side of the capacitor.

Could compressor 2 wire be on the wrong side of the capacitor??  I wired it the same way as I took it apart with all new capacitors.

Here is the wiring diagram from my unit, hopefully its the same:

It appears that it’s wired correctly unless the wires on the capacitor need to be on a specific side of the capacitor??  Or does it not matter one side or the other

Also does the board need 2 grounds one for each compressor?? Or does it share a ground meaning of one is hooked up it’s good to go??