[encantotom]

there are two errors that it might be. one is that there is an issue between the engine and the vmspc box (which mean more than likely you might have a wire switched). i think it is unlikely but possible that there is something wrong between the plug and the ddec on the engine.

the second error is that there is something not set up right on your software or laptop. did you install the usb drivers for the vmspc?

did you check to make sure under advanced tab that it has selected the usb jib and that it is the right usb port selected?

i think the most likely culprit is the setup on your laptop and config on vmspc.

i know the wiring i gave you is right because i recently installed the pigtail cable on two different newells that way.

i emailed you my phone number. call if you want to talk through it

tom