03-20-2017, 09:52 AM
Changing Rear Cam on my 88
I purchased a set of Wire Fish Rods from Harbor Freight. ( I hope it's ok to use that name here) They are a series of fiberglass rods that screw together. I was able to run from the bedroom to the living room, Curb Side, through Bath and Kitchen by simply adding rods as it progressed. A bit of wiggling is always helpful. Now I am struggling to get the rather large connector down the windshield post and I will have it done.
I replaced the round glass camera port with an ABS piece and let the new camera penetrate so it looks good and has not impaired the infra-red feature.
The new monitor is smaller than the original, so I fabricated a bezel from ABS also.
Changing out the cb whilst I'm in there. Pete
I purchased a set of Wire Fish Rods from Harbor Freight. ( I hope it's ok to use that name here) They are a series of fiberglass rods that screw together. I was able to run from the bedroom to the living room, Curb Side, through Bath and Kitchen by simply adding rods as it progressed. A bit of wiggling is always helpful. Now I am struggling to get the rather large connector down the windshield post and I will have it done.
I replaced the round glass camera port with an ABS piece and let the new camera penetrate so it looks good and has not impaired the infra-red feature.
The new monitor is smaller than the original, so I fabricated a bezel from ABS also.
Changing out the cb whilst I'm in there. Pete