[CaptainGizmo]

I have our slides alignment checked every annual service. You can also set the Limits in the slides via the Control panel. Have Newell walk you through that sequence…it’s long. MOST IMPORTANTLY…AFTER SETTING, RUN A FULL CYCLE IN EXTEND/RETEACT IN NORMAL MODE!!!!! This is needed in order to Save the settings. We learned the hard way after many End Wall errors.

Finally, it’s not uncommon to have misalignment when your coach isn’t on level ground. Running them full cycle on nice level ground usually gets them corrected for me.

Oh yeah…would be foolish of me to not say the obvious…CHECK YOUR SLIDE PATH!!! I’ve known (and seen) many who’ve said “all ok”, only to find a kids toy jammed into the slide trough!