[hypoxia]

Thinking about water intrusion so I checked the salon slide roof for sagging .  The center is the same as the ends and halfway between each end and the center is 1/8" or less "sag", that seems reasonable.  This was measured with the slide fully extended.  Where the slide sidewall meets the top it looks very well sealed also.  I need to check the slide wipers although I don't see how a slide wiper can possibly clear off all of that water when retracting.  Then the issue is how to keep it off of the bearings?  The W rail and the bearings need an umbrella although a bearing with stainless balls would probably resolve the problem, methinks.