Brought coach up to travel height this morning and brought the slides in. The front slide floor is fairly high on the back end under the dinette. Never seen it come in like this. Tried putting it back out and back in, even moved the coach to flatter ground and did it again but no luck. Anyone seem this before? Something I should be worried about?
Paul
Coach #540
2000 Double Slide, Bath and a half, Average sized fan for its age
Fulltiming for a while around CO
Yes, we had the floor done. It was about 2 months ago at this point, so we've had quite a number of cycles on the slide since then and the other day was when this started. It's this way now every time we bring the slide in. With the slide out, everything is flush and level and the gap looks about the same as it did when the floor were finished. One thing that was different is that where we had camped for about a week when this occurred is that we were on a fairly decent slope with the front of the coach being low - steep enough that raising the front as high as it would go and dropping the rear as low as it would go we were still not quite level.
We pulled the slide in today to change sites and I took a look at the outside while it was in. The top rear (by the dinette where this height unevenness is) seems to be pulled in a bit far at the top of the slide whereas the bottom of the slide appears to be the right depth. You can see the difference between top and bottom in the attached pic.
Paul
Coach #540
2000 Double Slide, Bath and a half, Average sized fan for its age
Fulltiming for a while around CO
Had that happen to my front slide. Found that the ceiling in the bay under the back of the bay came loose and the floor pulled it up had to pull the panel down and rescuer with aluminum a/c tape. Just my 2 cents.