RE: Tag dragging to easy -
CHRIS 1999 2 Slide - 04-13-2018
Thanks Brad but we're going across mostly on I-40 and I saw your previous post on how bad you said those roads were. That would be nice if there was a Road-Buddy App, theres a summer project for you Brad when your not slapping mosquitos.
RE: Tag dragging to easy -
Brad Townsend - 04-13-2018
Not much for mosquitos here but near the woods are the black flies/Mayflies. The RV sites are on a flat top hill so we tend to get a breeze which keeps them away. Must be some techno person out there that could develop a Road-Buddy app. I am not that techno savy.
RE: Tag dragging to easy -
CHRIS 1999 2 Slide - 04-17-2018
Brad didn't you know that the Maine state bird is not the chickadee but the black fly.
RE: Tag dragging to easy -
Brad Townsend - 04-17-2018
Ayhhyuh my mom is from Lincoln herd it plenty. Lived 1 year in Caribou, Mosquitos are awful when the sun goes down all summer.
RE: Tag dragging to easy -
Brad Townsend - 06-21-2018
Update: found a significant air leak above wet tank. a compression fitting just needing to be tightened a bit more but in a very tight area but got it. Before the 110 compressor couldn't stay up with it now only runs 11 minutes. Also noticed some bubbles coming from a plastic unit plumed into the same area as the loose compression fitting. I guess it would be a junction area where three lines come in and this plastic thing with 2 small wires on it. Anyone know what that plastic thing is?
It looks to be about 2 inches tall about 5/8 thick and 1 1/4 wide with tapered sides. Held together with what looks like #10 bolts going up from the bottom. The 2 wires are at the top, one on either side. This unit leaks at the top. I have tightened the bolts to the point that I think any tighter would break them. And it still leaks a small amount. I assume it is a type of sensor but not what for. with the wires off the gauge on the dash still works. Little by little.
RE: Tag dragging to easy -
kyleb - 06-21-2018
(06-21-2018, 01:35 PM)Brad Townsend Wrote: Update: found a significant air leak above wet tank. a compression fitting just needing to be tightened a bit more but in a very tight area but got it. Before the 110 compressor couldn't stay up with it now only runs 11 minutes. Also noticed some bubbles coming from a plastic unit plumed into the same area as the loose compression fitting. I guess it would be a junction area where three lines come in and this plastic thing with 2 small wires on it. Anyone know what that plastic thing is?
It looks to be about 2 inches tall about 5/8 thick and 1 1/4 wide with tapered sides. Held together with what looks like #10 bolts going up from the bottom. The 2 wires are at the top, one on either side. This unit leaks at the top. I have tightened the bolts to the point that I think any tighter would break them. And it still leaks a small amount. I assume it is a type of sensor but not what for. with the wires off the gauge on the dash still works. Little by little.
Sounds like the low air pressure sensor
RE: Tag dragging to easy -
Brad Townsend - 06-22-2018
That's it. Are these easily found?
RE: Tag dragging to easy -
Brad Townsend - 06-22-2018
Just ordered one off ebay. Thanks.
RE: Tag dragging to easy -
kyleb - 06-22-2018
(06-22-2018, 03:22 AM)Brad Townsend Wrote: Just ordered one off ebay. Thanks.
What would we do without ebay ? !
Be careful with those little screws, if you drop one, they can be very difficult to find & the ones on my new switch didn't match the old one - spent over an hour looking for it. The gravel floor didn't make it any easier either!
It was brass, so a magnet wasn't any help.
RE: Tag dragging to easy -
Brad Townsend - 06-25-2018
Thats a good point. I am parked on fine sand.