You are not logged in or registered. Please login or register to use the full functionality of this board...


Radiant heat floor wiring question
#11

Thank you Richard! I'll try and be careful.

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply
#12

And two wet saws………..

If your coach is like mine, Newell put down a layer of thinset, then a layer of fiberglass mesh, then another layer of thinset, then the tile. There is a reason it held up so well over the years.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#13

Yes it seems to be just like that so the heated mat is between the second layer of thinset and the tile? I'm using an 1/8 in diamond Burr on a high speed rotatory to take the grout out to the thickness of the tile which is 3/8". Trying not to get into the heating blanket.

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply
#14

I didn’t get into the heating blanket. Both of mine have failed, and I have disabled the circuits.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#15

Do you have concerns I should know about?

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply
#16

One of them developed a hot spot that would burn you if you stepped on it. In an abundance of caution with regard to short circuits I turned off the breakers to prevent inadvertent activation

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#17

Good enough for me, I will stop this project. Thanks

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)